Shimano EW-SD50 User Manual download pdf (Page 4)

Important Notes

• When determining wire lengths using the following guide, always round up to the next

closest wire length after determining your final measurement.

• If your frame has multiple battery mounting locations, choosing the lowest possible point

can accommodate better water bottle placement, and help to keep your center of gravity

low for improved bike handling control.

• Frames with vertically mounted shocks must have the battery mounted in the high posi-

tion, to avoid causing interference between the shock motor unit and the battery.

• Never mount the battery underneath the downtube.

• Suggested wire routing methods illustrate only one example of possible routing methods

for each frame/shock/battery configuration listed. Other methods may be appropriate as

long as all clearances are checked.

• Never allow any exposed shifter cable, housing, or brake lines to move against or across

any iCD wires. Make sure to check for clearance through the entire range of shock travel.

This guide is designed around three basic MTB frame types: hardtails, full suspension bikes

with horizontal-mount shocks, and full suspension bikes with vertical-mount shocks. Use the

instructions for the frame type that best matches yours.

1 2 3 4 5 6 7 8 9 ... 15 16

No comments

Shimano EW-SD50 User Manual Page 4