Shimano SC-M500 Specifications

SI-7AP1ESERVICE INSTRUCTIONSCycle ComputerSC-6502 / SC-6501/ SC-M500t

(4)Entering the number of chainring and sprocket teethThe display will then change to that shown in fig10.Enter the values staring from the outer chai

If the cassette has seven sprockets, press switch “A” once to change theflashing “21” to “--”, and then press switch B once. This will indicate thatt

Trouble Shooting* Speed is not displayed.• Check that the speed sensor and the main unit arepositioned correctly (distance and facing direction).• Che

Be careful not to pay excessiveattention to the computer data whileriding, otherwise you might have anaccident.NOTE; * The all clear (AC) button is us

2. Display Contentsmode 1 mode 2Current speed (VEL)Clock (CLK)Trip time(TIM)Trip distance(DST)ODO meter(ODO)Stop watch–trip distance(DST STW)Stop watc

(1)Current speed (VEL)km/h, mphWhen maindisplay cadenceappears on topCurrent speedwill appear inthe sub - display0.0 (2.0) - 130.0km/h 0.0 (1.2) - 80

(4)Trip distance group (TIM, DST, MAX, AVE)(5)ODO meter (ODO)0- 99999.9km, mile(6)Stopwatch (STW)groupThis group includes stopwatch trip distance aver

(7)Cadence (rpm)Cadence is calculated from the F- Rgear tooth numbers and currentspeed.Note;Cadence always appears duringbicycle movement regardless i

6. Setting tolerances5. Viewing data after removing thecomputer from the bracket mountThe data can still be viewed even when the computer has been rem

()()7. Installation to the bicycle8. Data input (*data for up to 4 bicycles can be entered)Install the levers to the handlebars. Then connect and adju

The value will increase by 5mm each time switch “A” is pressed.The value will change rapidly when switch “A” is pressed continuously.Once the desired